| |
FLIPPA
Desk Conversion Base (B190)
Assembly Instructions |
| |
- Stand
Support Bracket
vertically
on Base
.
- Place
screw
(1/2"
x 1/4" BSW) in rear hole on Base
.
- Attach
washer
and
nut
from
underside of Base.
- Repeat
steps 2 and 3 with second screw and nut.
- For
10 Panel capacity, place one Mounting Bracket in line with centre hole
of Support Bracket
.
- Insert
screw
(1/2"
X 1/4" BSW) from front and attach washer
and
nut from rear.
- Insert
screws
(2
x 1/2" X 1/4" BSW) in bottom of Mounting Bracket
and
attach washers
and
nuts from underside Base .
- Tighten
all nuts.
- Remove
bumpons
from
strip.
- Place
bumpons
on
4 corners of underside of Base,
pressing firmly to stick in place.
|
| |
| NOTE: |
- Support
Bracket must always be fitted for stability of unit.
- For
20 Panel capacity, two only Mounting Brackets are required. Each to
line up with outside two holes on Support Bracket and corresponding
outer holes on Base.
- Multiple
Assembly Instructions
|
