How To Assemble
 

Hang-A-Plan PREMIUM Front Loader Trolley with Systems Shelf
 
Trolley
  1. Locate the back plate (fig. 3A) between frames (fig. 2) and fix with four 8 x 20mm bolts and washers (fig. 4 & 5).
  2. Screw two bolts and washers into bottom of side frames through base plate (fig. 3B).
  3. Screw two castors (fig. 6) into nutserts on bottom of side frames through base plate (fig. 3B). Screw 1 castor into nutsert on centre of base plate.
  4. Screw remaining two castors with washers into nutserts on rear of side frames.
  5. Place the top channel (fig. 1) in position on top of side frames and fix with four 8 x 20mm bolts and washers.
  6. Tighten all bolts with combination spanner supplied.
 
Systems Shelf
  1. Place the systems shelf on the top channel with the open side facing forward away from the back plate. Slide the two fixing brackets into notches on both sides of the systems shelf and fix with screws and washers into the nutserts on each side of the top channel.
  2. You can now hang your binders (purchased separately) onto the top channel, using the small clip on the handle of the binder.
 

                                         

                                                                       Fully Assembled Premium Front Loader Trolley

CONTENTS:

  Trolley:       System Shelf:  
1.
 Top Channel x 1
9.
 Systems Shelf x 1
2.
 Side Frame x 2
10.
 Fixing Brackets x 2
3A.
 Back Plate x 1
11.
 Flat Washers x 4
3B.
 Base Plate x 1
12.
 Combination Bolt x 4
4.
 8 x 20mm Hex Head Bolts x 10      
5.
 8 x 16mm Flat Washers x 15      
6.
 Castors x 5      

[Index] [About Us] [News] [New Products] [Products] [How To] [Distributors] [Contact Us]